It is possible to use an SD memory card with the Sensus Connected Touch option. This article describes how to use an SD memory card.
It is possible to use an SD memory card with Sensus Connected Touch. The card slot can be found in the device that is located in the glove compartment.
It is possible to use an SD memory card with memory up to 32 GB. Note that if you have the iGo application then this app is stored on the SD memory card.
It is possible to both read and save information on an SD memory card. If you use a USB memory for Sensus Connected Touch, it is not possible to save information on it. USB memory can only be used to read information.
To remove an SD memory card, follow the instructions below:
Go to Settings in the app launcher.
Select Advanced settings and then Storage.
Select Unmount the SD card and press OK.
To remove the write protection from an SD memory card, follow the instructions below:
Remove the memory card by following the instructions under the heading 'Removing the SD memory card'.
There is a small switch on the SD card. Adjust the switch to the write position, and then reinsert the card in Sensus Connected Touch.
S60, V60: model year 2011-2014
S80: model year 2012-2014
V40, V40 Cross Country: model year 2013-2014
V70, XC70: model year 2012-2014
XC60: model year 2011-2014 (model year 2011 applies only to cars manufactured after week 46)
It is possible to install Sensus Connected Touch for model year 2014 and later, but not to cars equipped with Sensus Connect.
Sensus Connected Touch